Preparing your notebook for use
Switching the notebook on for the first time
Switchingonforthefirsttime
We recommend that the notebook is supplied with po w er through
the mains adapter during this procedure.
When you switch your notebo ok on for the first time, the supplied software
is installed and configu red. Because this installation procedure must not be
interrupted, y ou should set aside enough time f or it to be fully completed and
connect the notebook to the m ains outlet using the m ains adap ter.
During in stallation, the notebook must only be rebooted when you are requested to do so!
You will be prompted to create a backup copy o f the pre-installed operating system. This
backup copy can be used later to restore your notebook to its delivery con figuration.
You can find information on how to restore the operating system, drivers, manuals
and special software in the Recovery Process manual.
Your operating system is pre-installed on the hard disk to help you when you
start using your notebook for the first time.
1
► Switch on the notebook ( 1).
► During installation, follow the on-screen instructions.
Consult the operating system manual if anything is unclear about the requested input data.
If a Windows operating system is installed on your notebook, you will find additional
information on the system and drivers, help programmes, updates, manuals etc. on
your notebook or on the Internet under "www.fujitsu-siemens.com/support".
6 - English 10600962235, edition 1
To Next Page
Loading...
