Fujitsu SPARC M10-4 - Restoring the Chassis; Restoring the System

Note -
Do not force the internal disk into the slot. Using excessive force may damage the
component or the chassis.
Note -
Ensure that the internal disks are firmly inserted and secured.
Note -
See the procedure for system-stopped maintenance for inactive/cold maintenance in a
single-chassis configuration.
2.
With the lever opened, hold the internal disk.
3.
Carefully insert the internal disk into the slot.
4.
Close the lever to secure the internal disk.
12.5.2 Restoring the chassis
1.
Insta ll the front cover.
For details, see "6.5.3 Installing the front cover."
12.6 Restoring the System
This section describes the procedures for restoring the system after replacement,
addition, and removal of internal disks. The restoration procedure differs depending
on the maintenance type as follows:
■
Active/Hot maintenance
■
Active/hot maintenance (with DR)
■
Inactive/Hot maintenance
■
System-stopped maintenance
12.6.1 Active/Hot maintenance
The procedure may vary depending on the configuration of the hard disk drive.
When the system is configured with a hardware RAID
The operation varies depending on the hardware RAID configuration (RAID 0, RAID
1, or RAID 1E). For details, see "14.2.10 Replacing a failed disk drive" in the Fujitsu
M10/SPARC M10 Systems System Operation and Administration Guide.
Chapter 12 Maintaining the Internal Disks 237