Need help?Do you have a question about the Fujitsu SPARC Enterprise M3000 and is the answer not in the manual?
General| Processor | SPARC64 VII |
|---|---|
| Memory Type | DDR2 |
| Operating System | Solaris |
| Memory | Up to 64 GB |
| Storage | Up to 4 TB |
| RAID Support | RAID 0, 1, 5, 10 |
| Network Interface | 2 x 10/100/1000BASE-T |
| Expansion Slots | 4 PCI Express |
| Power Supply | Redundant power supplies |
| Form Factor | 2U |
| Number of Processors | 1 or 2 |
Explains the capabilities and features of the Remote Cabinet Interface (RCI).
Details the specific operational functions provided by the RCI, including monitoring and control.
Outlines the various connection patterns and configurations for RCI units.
Provides a general introduction to the RCI setup procedures and considerations.
Details the step-by-step process for performing an initial RCI setup.
Describes how to add an RCI I/O unit to an existing RCI system.
Explains the procedure for adding an RCI base cabinet to the RCI network.
Covers the steps involved in replacing an existing RCI I/O unit.
Details the process for replacing an RCI base cabinet within the RCI network.
Provides comprehensive details and syntax for the 'setrci' command.
Details the syntax and usage of the 'setrcic' command for power control.
Lists and explains the error status codes associated with the 'setrci' command.
Lists and explains the error status codes for the 'setrcic' command.
To Next Page