3-2 C120-E360-06EN
CHAPTER 3 Command Reference
•PRIVILEGES
You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
•OPTIONS
The following options are supported:
addconfig Adds an RCI I/O unit or host.
When an RCI I/O unit is added, the RCI I/O unit newly connected to RCI
is searched for and found, and then an RCI address is assigned.
When a host is added, it is also added to the RCI network. "-c set" must
be executed beforehand on the added host to set the RCI address for the
host.
replaceconfig Replaces an RCI I/O unit or host.
When an RCI I/O unit is replaced, the specified RCI address is assigned
to the substitute RCI I/O unit.
When a host is replaced, a substitute host is added to the RCI network
after the information of the host to be replaced is deleted from the RCI
network. "-c set" must be executed beforehand on the substitute host to
set the RCI address for the host. An RCI address cannot be specified
when replacing a host.
ledoff Stops the blinking CHECK LED of an RCI I/O unit. This specification is
used such as when the work for identifying an RCI I/O unit is completed.
idpin Displays the RCI address of the RCI I/O unit whose ID-PIN has been
pressed.
This specification is used when checking the RCI address
of an RCI I/O unit.
-c stat Displays the status of the RCI network.
-c init Initializes the RCI setting.
-c set host_no Sets the address specified by host_no for the RCI address. An integer
number ranging from 0 to 32 must be specified for host_no. The
specification of one address cannot be duplicated among hosts connected
to RCI. In addition, addresses must be assigned sequentially starting from
1. "-c set" must be executed in the state where initialization has been
completed by "-c init".
-c initconfig Make the RCI setting at initial setting. "-c initconfig" must be executed
when the RCI setting has been initialized by "-c init" and the RCI address
has been set by "-c set".
-c addconfig Makes the RCI setting for when an RCI I/O unit or host is added.
-c replaceconfig Makes the RCI setting for when an RCI I/O unit or host is replaced.
-c ledon Makes the CHECK LED of an RCI I/O unit blink.
-c ledoff Stops the blinking CHECK LED of an RCI I/O unit.
To Next Page
Loading...
Need help?
General