C120-E360-06EN 2-1
CHAPTER 2 Setup of the RCI for Operation
1
This chapter describes setup information for use of the RCI.
2.1 Overview of RCI Setup
The RCI can be set up as follows.
Note: RCI setup as explained in this chapter is carried out by authorized service
personnel.
z Prepare a serially-connected PC or a PC connected to the XSCF-LAN, specify its
IP address, establish a connection to the XSCF, and use the XSCF shell.
The RCI is configured in the following types of setup:
z RCI Setup for Initial Installation
z RCI Setup for Addition of an RCI I/O Unit
z RCI Setup for Addition of an RCI Base Cabinet
z RCI Setup for Replacement of an RCI I/O Unit
z RCI Setup for Replacement of an RCI Base Cabinet
Each setup for RCI configuration is explained in the following manner:
- Explanation -
1 The explanation of each RCI setup begins with a description of the overall setup
flow.
2 Setup procedures are then explained with setting examples.
• For detailed explanations and details on options of XSCF Shell commands, see the
man pages or, Chapter 3, "Command Reference."
• This section does not explain in detail the connection between the XSCF and a PC
or terminal and methods for logging in to the XSCF. For details, see the XSCF
User’s Guide.
To Next Page
Loading...
Need help?
General