En-2
1. SAFETY PRECAUTIONS
Let the customer keep this installation manual because it •
is needed when the air conditioner or remote controller is
serviced or moved.
WARNING
This mark indicates procedures which, if
improperly performed, might lead to the
death or serious injury of the user.
For the air conditioner to operate satisfactorily, install it as •
outlined in this installation manual.
Do not turn on the power until all installation work is •
complete.
CAUTION
This mark indicates procedures which,
if improperly performed, might possibly
result in personal harm to the user, or
damage to property.
Do not install where there is the danger of combustible •
gas leakage.
Do not install near heat sources, steam.•
2. ACCESSORIES
Name and Shape Q’ty Application
Installation manual
1
This manual
Operating manual
1
Instruction book
for operation
Battery
2
For remote controller
Tapping screw
2
For mounting the remote
controller
Remote controller
holder
1
For installing the remote
controller holder
installation
3.
INSTALLING THE REMOTE CONTROLLER
3.1. Load batteries (R03/LR03 x 2)
(1) Press and slide the battery compartment lid on the
reverse side to open it. Slide in
the direction of the arrow while
pressing the
mark.
(2) Insert batteries.
Be sure to align the battery
polarities ( ) correctly.
(3) Close the battery compartment lid.
CAUTION
Take care to prevent infants from accidentally swallowing •
batteries.
When not using the Remote Controller for an extended •
period, remove the batteries to avoid possible leakage and
damage to the unit.
If leaking battery fl uid comes in contact with your skin, •
eyes, or mouth, immediately wash with copious amounts of
water, and consult your physician.
Dead batteries should be removed immediately and •
disposed of properly, either in a battery collection
receptacle or to the appropriate authority.
Do not attempt to recharge dry batteries.•
NOTES
Never mix new and used batteries, or batteries of different •
types.
Batteries should last about 1 year under normal use. If the •
Remote Controller’s operating range becomes appreciably
reduced, replace the batteries and press the RESET button
with the tip of a ballpoint pen or other small object.
3.2. Installing the remote controller holder
CAUTION
Check that the indoor unit correctly receives the signal •
from the remote controller, then install the remote
controller holder.
Select the remote controller holder selection site by •
paying careful attention to the following:
Avoid places in direct sunlight.
Select a place that will not be affected by the heat from a
stove, etc.
1.
REMOTE CONTROLLER HOLDER INSTALLATION
Install the remote controller with a distance of 7 m between •
the remote controller and the remote control signal receiver
as the criteria. However, when installing the remote
controller, check that it operates positively.
Install the remote controller holder to a wall, pillar, etc. with •
the tapping screw.
9371972084-02_IM_en.indd 29371972084-02_IM_en.indd 2 9/7/2010 7:20:23 PM9/7/2010 7:20:23 PM
To Next Page
Loading...
