¢
Function settings of remote controller
Perform the following operations within 3 minutes after turning on the power.
1. Enter the “Service” screen.
Back:
Setting:
Date and time
Submenu
[
1/2
]
Monitor
Screen
Filter sign
R.C. sensor control
Room temp. display
Off
Off
Mo
10:00
Menu
Back
:
Setting:
Service
Mo
10:00
Function setting
Error history
I.U.address verification
Version
Test run
2. Press the [Screen switch button (left)], [Enter button], and [Cursor button (downward)] simul-
taneously for 5 seconds.
NOTE: It may not function if the buttons are pressed too hard.
3. Switch to the “R.C. function setting” screen.
Back
:
Setting:
R.C.
function setting
Mo
7:07 PM
Set temp. range (Initial)
Room temp. correction
Operation mode exemption
Operation mode exemption
The specified operation mode can be removed from the operation mode menu of the wired
remote controller.
This does not mean that the operation mode is exempted from the indoor unit.
Check the operation modes you want to exempt.
NOTES:
• In the case of dual remote control operation, make the primary unit and the secondary
unit setting same. Even if only the primary unit is set, it will not be reflected at secondary
unit.
• After setting, always perform operation (Operation in other than the exempted modes).
Since the indoor unit memorizes the last operation, overwriting the memory operation
mode is unnecessary.
- 25 -
ZONE CONTROL
SYSTEM
To Next Page
Loading...
