5
OPERATING THE VACUUM
Turning the Vacuum On
Hold the vacuum handle firmly in your hand and switch the power button to the “on”
position indicated by the “I”.
Hose Cleaning
1) To clean with the hose attachment, remove the hose from the inlet. This disables the
brushroll allowing for better cleaning performance with the hose.
2) For added convenience, a dusting brush is attached to the end of the hose. To extend
the brush twist the brush to unlock it. Push the brush away from the hose and twist it
in the opposite direction to lock it into place. Retract the brush when not in use.
3) Re-attach the hose to the inlet to activate the brushroll for carpet cleaning. Push the
hose onto the inlet until it clicks. Doing so will ensure the hose is properly attached
and the brushroll is activated.
Important:
Do not push the hose too far onto the inlet. If the hose is pushed too far onto the
inlet, the brushroll will not activate.
To Next Page
Loading...
