FUNAI DDVR-6830 - Page 21

1-9-2 H9903FW
10. Press [CLEAR/C.RESET] button on the remote
control unit.
Fig. h appears on the screen.
When “OK” appears on the screen, the factory
default will be set. Then the firmware renewal
mode is complete.
11. To exit this mode, press [STANDBY-ON] button.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : OK
EXIT: POWEREEPROM CLEAR : CLEAR
"
*******
" differ depending on the models.
Fig. h