FUNAI LF320FX4 - Using Your TV Functions; TV Standby and Power; Adjusting Volume; Switching Channels

16
English
4Use your TV
Switching on your TV or putting it in Standby
mode
To Turn the TV On from Standby or Off to Standby
• Press on the Front panel or the Remote control.
Adjusting volume
To decrease or increase volume
• Press VOL ◄ / ► on the Front panel or press VOL + / − on the
Remote control.
VOL ◄ : Volume Down
VOL ► : Volume Up
To mute or unmute sound
• Press on the remote control to mute the sound.
• Press again or VOL + / − to recover the original sound.
Switching channels
To select Channels by using CH ▼/▲ or CH + / −
• Press CH ▼ (Down) / ▲ (Up) on the Front panel or press CH + /
− on the Remote control.
To select Channels by using the NUMBER buttons
• For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
– When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
– When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
• Energy consumption contributes to air and water pollution. When the AC Power cord
is plugged in, your TV consumes energy with a very low Standby Power consumption.
Remote Control
TV
Remote Control
TV
Note(s)
• To select the non-memorized channels, use the NUMBER buttons.
• No Signal will appear on the TV screen after the subchannel broadcast is over.
• Audio only program message will appear on the TV screen, when you receive only
sound signal.
TV
Remote Control
Digital TV operation
Analog/Cable TV operation