The inflating should be done while the tire is cold.
Tire maintenance
Tire tread depth should be checked regularly.( Shallower tread means less grip of tire). You
must stop to use the vehicle if the tire is pierced, disassemble the tire and check it carefully.
Tire maintenance should be done by an authorized technician. Tire should be replaced
immediately when it is distorted or damaged.
Tire replacement
It is important to use the correct size and standard tire as per our specification (see details in
technical specification sheet)
Don’t use the used tire if you are not sure its previous service condition.
Tire aging
Tire aging is unavoidable even the tire is not ever used or just used a few times. Tire aging is
mainly reflected in the cracked section on side of tire and tire tread, sometimes the tire is
distorted as well. The used and aged tire should be checked and confirmed if it is ok to use
again by an authorized technician
TECHNICAL SPECIFICATION SHEET
single cylinder, 2 stroke, forced air cooling
Petrol mixed with 4% 2-stroke engine oil
automatic with centrifugal clutch
front & rear 3.00-4 with 4.00 P.s.i operation pressure
and 24 P.s.i Max. inflate
front 4.10-6 with 7.00 P.s.i. operation pressure and 20
P.s.i. Max. inflate , rear 13.00 x 5-6 with 7.00 P.s.i.
operation pressure and 20 P.s.i Max. inflate .
front and rear disc brake with mechanical control
Dry Weight ( ATV with 4” / 6” wheel)
Dimension (mm) ( ATV with 4” / 6” wheel)
1065×590×740 / 1100 x 590×765
Seat height (mm) ( ATV with 4” / 6” wheel)
To Next Page
Loading...