FUNKY MONKEY BARS Boxing Bag - Assembly Tips Continued; Tools Required for Installation; Frame Level and Squareness; Installation on a Slope

Page 4
Check assembly is 100%
level, square & straight.
PLAN VIEW
SIDE VIEW
IT IS CRITICAL YOUR MAIN FRAME IS 100% SQUARE AND LEVEL
(indicative diagram shown)
If your frame is not straight or level remove pegs, loosen
grub screws, re-adjust re-tighten and re-peg the frame.
ASSEMBLY TIPS (continued)
INSTALLATION ON A SLOPE
If your frame is being installed on a slope ensure the monkey
ladder bar is level. Either install at different heights on the legs
or dig down at one end until level.
1x
8mm Allen key
(Included
with frame)
1x
Soft Hammer
(Not included)
TOOLS REQUIRED FOR INSTALLATION - (varies for each accessory)
1x
Spirit Level
(Not included)
1x
3m Step Ladder
(Not included)
1x
Tape Measure
(Not included)
1x
17mm Rachet
(Not included)