E
ellisscottAug 11, 2025
How to light Furrion Ranges surface burners?
- SSylvia RobinsonAug 11, 2025
To light the Furrion Ranges surface burners, push in and turn the Surface Control knob to the appropriate position until the burner ignites, then adjust the control to your desired flame size. Also, ensure that the gas supply valve is open. If the burner still doesn't light, turn it off and use a small-gauge wire or needle to clean any blocked ports or slots. Once the burner flame is lit, push the burner control knob in for at least 5 seconds.