Furuno 1824C-BB - System Configurations

v
SYSTEM CONFIGURATIONS
All NavNet products incorporate a "network circuit board" to integrate each NavNet product
on board through an optional LAN cable (Ethernet 10BASE-T). Each NavNet product is
assigned an IP address to enable transfer of images between other NavNet products. For
example, video plotter pictures can be transferred to a radar and vice versa. Pictures
received via the NavNet may be adjusted at the receiving end.
The number of processor units which may be installed depends on the number of network
sounders connected. For a system incorporating three or more NavNet products, a "hub" is
required to process data.
For one network sounder: one radar and three plotters, or four plotters
For two network sounders: one radar and two plotters, or four plotters
Heading sensor
Navigator
Echo sounder
Rectifier
RU-3423
GPS receiver
GP-310B/320B
12 - 24 VDC*
Network
Sounder
ETR-6/10N
ETR-30N
Other NavNet
system
(GD-1920C-BB, etc.)
Antenna Unit
MODEL
1834C-BB
MODEL
1934C-BB
MODEL
1944C-BB
Processor unit
RPU-015
100/110/115/220/230 VAC
1φ, 50/60 Hz*
Monitor
(Local supply)
(See next page)
MODEL
1954C-BB
Control unit
RCU-017
Power Supply
Unit PSU-005
*: The power for the power supply unit
and display unit must be drawn from
the same power source.
Facsimile
Receiver
FAX-30
MODEL1824C-BB
PUSH TO ENTERPUSH TO ENTER
DEFDEF
MNOMNO
VWXVWX
_'#_'#
POWERPOWER
RANGERANGE
TXTX
00
JKLJKL
44
77
STUSTU
55
88
ABCABC
2211
BB
GAINGAIN
ALARMALARM
EBLEBL
VRMVRM
PQRPQR
YZ&YZ&
66
99
DISPDISP
EE
MENUMENU
CC
DD
CLEARCLEAR
GHIGHI
33
SAVESAVE
MOBMOB
HIDEHIDE
SHOWSHOW
AA
POWER
DATA 3 NETWORK CONT DATA 1DATA 2
DJ-1
SLAVE DISPLAY
RGB OUT
NTSC/PAL
2
GND
3
INPUT
12-24 VDC
1
CARD SLOT
3
2
1
GND
F.G.
12 VDC
OUTPUT
OPTION
ARPA
ARP-11
: Standard
: Option
: Local supply
NavNet system: Model 1824C-BB/1834C-BB/1934C-BB/1944C-BB/1954C-BB