What to do if Furuno Marine Radar does not transmit?
If your Furuno Marine Radar isn't transmitting after warming up and pressing the [STBY TX] key, the issue might be within the antenna unit itself. It's recommended to request service to address this problem.
What to do if a key is not working on Furuno Marine Radar?
If pressing a key on your Furuno Marine Radar doesn't produce the expected result, the key itself may be faulty. In this case, it's best to request service for your radar.
How to fix Furuno if it doesn't turn on?
If your Furuno Marine Radar doesn't seem to be powering on when you press the [POWER] key, here are a few things to check: * First, try adjusting the control panel back-lighting in the OTHERS menu. * Second, the battery may have discharged, so ensure it's properly charged. * Third, inspect the fuse in the power cable to see if it has blown.
What to do if adjusting gain doesn't work on Furuno Marine Radar?
If you've adjusted the gain on your Furuno Marine Radar with both A/C RAIN and A/C SEA turned off and are still experiencing issues, it's recommended to check the signal cable for any signs of damage.
General| Brand | Furuno |
|---|---|
| Model | Marine Radar |
| Category | Marine Radar |
| Language | English |
DANGER, WARNING, CAUTION notices provide critical safety information for operation and installation.
Information on electromagnetic radiation from the antenna and safe distances.
Safety precautions for working on the antenna unit, including using safety belts.
Identifies and explains the function of each control on the radar's main panel.
Explains the various symbols, icons, and data displayed on the radar screen.
Methods for measuring target distance using range rings, cursor, and VRM.
Methods for measuring target bearing using the cursor and EBL.
How to reduce interference from other radars using the Interference Rejection (IntReject) control.
How to set up a guard zone for intruder detection and alarms.
Detailed explanation of all items available in the OTHER MENU.
Outlines a recommended maintenance program for ensuring optimal performance.
Instructions for safely replacing blown fuses in the power supply.
A table of common problems and their potential solutions.
Guidelines for siting, handling, mounting, and connecting the antenna unit.
Instructions for mounting and connecting the display unit, including cable management.
Procedures for fine-tuning the radar after installation, including tune, heading, and sweep timing.
Critical safety warnings and installation notices for the ARP-10 auto plotter.
Overview of the ARP-10's capabilities for target acquisition, tracking, and data display.
Step-by-step guide to enable and configure the Auto Plotter feature.
How to manually acquire and track radar targets using the ARP-10.
How to configure CPA and TCPA alarm limits to warn of potential collisions.
Step-by-step guide for installing the ARP-10 board into the display unit.
To Next Page