What to do if the SYSTEM FAIL LED lights up red on Furuno VR-7000S?
If the SYSTEM FAIL LED lights up red on your Furuno Data Loggers, it indicates a system malfunction. Check the alert list on the RAP for the alert number, and then refer to section 3.2 for the appropriate remedy.
Why is the BATTERY LED flashing on my Furuno VR-7000S Data Loggers?
The BATTERY LED flashes on Furuno Data Loggers while the battery is charging. Maintain AC power until the battery is fully charged, which should take approximately six hours.
How to fix AC LED not lighting on Furuno VR-7000S Data Loggers?
If the AC LED on your Furuno Data Loggers doesn't light up, it means there's no power coming from the ship's mains. You should check the breaker switches on the ship’s mains switchboard.
General| Category | Data Loggers |
|---|---|
| Manufacturer | Furuno |
| Model | VR-7000S |
| Operating Temperature | -15°C to +55°C |
| Type | Voyage Data Recorder |
| Standard | IMO MSC.333(90) |
| Protected Capsule Storage Capacity | 12 hours |
| Data Recording Period | 30 days |
| Protection | Fireproof, waterproof |
| Interface | Ethernet, NMEA 0183 |
| Power Supply | 24 VDC |
| Compliance | IMO, IEC |
To Next Page
