To Next PageTo Next PageWhat to do if the SYSTEM FAIL LED lights up red on Furuno Data Loggers?
If the SYSTEM FAIL LED lights up red on your Furuno Data Loggers, it indicates a system malfunction. Check the alert list on the RAP for the alert number, and then refer to section 3.2 for the appropriate remedy.
Why is the BATTERY LED flashing on my Furuno VR-7000?
The BATTERY LED flashes on Furuno Data Loggers while the battery is charging. Maintain AC power until the battery is fully charged, which should take approximately six hours.
How to fix AC LED not lighting on Furuno Data Loggers?
If the AC LED on your Furuno Data Loggers doesn't light up, it means there's no power coming from the ship's mains. You should check the breaker switches on the ship’s mains switchboard.
General| Model | VR-7000 |
|---|---|
| Category | Data Loggers |
| Manufacturer | Furuno |
| Operating Temperature | -15°C to +55°C |
| Standard | IMO MSC.333(90) |
| Data Recorded | Bridge audio |
| Capsule Type | Float-free capsule |
| Fixed Capsule Recording Duration | 48 hours |
| Input Voltage | 100-230 VAC |
| Data Storage | External USB drive |
| Compatibility | Compatible with various bridge equipment |
Manual describes procedures for VDR setup and outlines key steps.
Lists essential hardware and software required for VDR setup.
Lists registered trademarks of Microsoft and other companies.
Provides context about screenshots and OS differences.
Important usage warnings, including VR-3000 compatibility.
Details maintenance viewer components and recommended PC specifications.
Provides step-by-step instructions for installing the VDR Maintenance Viewer software.
Guides on setting IP addresses and internet options for the PC.
Explains the physical connection process between the PC and the VR-7000.
Instructions for launching the VDR Maintenance Viewer application.
Provides procedures for removing the VDR Maintenance Viewer.
Describes the different areas of the VDR Maintenance Viewer display.
Guides on configuring the VR-7000 using the VDR Maintenance Viewer.
Setup instructions for radar/ECDIS image recording.
Configuration steps for serial channels (RS-422).
Configuration of analog signals from sensor adapters.
Configuration of digital signals from sensor adapters.
Settings for microphone and VHF audio.
Displays alert status and provides alert search functionality.
Stores and allows searching of VDR events.
Provides information about the system hardware status.
Setup instructions for the Junction Box.
Controls and displays consumable parts status.
Configuration of the system network settings.
Sets system-related functions and parameters.
Sets and displays software-related operations and versions.
Setup and configuration of the GPS navigator.
Sets and displays the ship's information.
Functions to send data from VDR to PC via LAN.
Setup for sensors connected via LAN.
Setup for sensor adapters.
Setup for the Alert Management System.
Setup for the Video LAN Converter.
Setup for the image interface for radar/ECDIS.
Setup for the Audio I/F board.
Procedure for backing up configuration data to a startup CF.
Procedure for backing up configuration data to a PC.
Restores default setting data to DRU, Long Term Device, CF, and Viewer.
Shows how to delete data from DRU and Long Term Device.
Initializes and creates a Long Term Device.
Features for downloading and updating VDR system software.
Allows changing of serviceman and audio passwords.
Compares integrity of DRU and Long Term Device recordings.
Saves and configures software history (communications record).
Sets equipment settings in batch and creates data files.
Controls import and export of equipment settings.
Enables RAP operation from a PC.
Provides access to status monitor and error lists.
Guides on setting the Equipment ID for sensor adapters.
Configures sensor adapters connected to the network.
Saves sensor adapter log files to a medium.
Provides instructions for updating sensor adapter firmware.
