7. SETTING FOR SENSOR ADAPTER
7-9
5. Enter “/usr/sbin/version“ on the command prompt to confirm the program version.
The program version is shown on the command prompt.
Note: The image shown above is an example. The program version number may
be different.
6. After confirming the program version, enter “exit“ to finish the telnet command.
7.4.3 How to update the firmware program
1. Delete the version number from the firmware binary file name.
2. Activate the maintenance program of the sensor adapter MC-3000S.
3. Activate the command prompt of Windows
®
.
4. Change the current directory to the directory where the firmware binary program
is saved.
In the example shown below, binary file is saved at .
Note: Change the current directory to the one where the binary file is saved.
5. Enter “ftp 172.31.17.108“ on the command prompt.
Confirm that “220-MC3000_CS_MAINTENANCE“ is shown.
㸠㩷㩷
After the confirmation the program version, enter “exit” .
㸠㩷㩷
After the confirmation the program version, enter “exit” .
㸠㩷㩷
After the confirmation the program version, enter “exit” .
㸠㩷㩷
The command to confirm the program version.
㸠㩷㩷
The command to confirm the program version.
㸠㩷㩷
The command to confirm the program version.
Boot program
Boot program
Main program
Main program
Maintenance program
Maintenance program
Example
䋺
2450081-01010088_mc_cs_mainpg.bin
Program number Version number
Delete the version number from the file name.
Example
䋺
2450081_mc_cs_mainpg.bin
㪚㪑㩷㪳㫌
㪻㪸㫋㪼
%
EF>WRFCVG
㸠㩷㩷
The command to change the current drive
㸠㩷㩷
The command to change the current drive
㸠㩷㩷
The command to change the current drive
㸠㩷㩷
The command to change the current directory
㸠㩷㩷
The command to change the current directory
㸠㩷㩷
The command to change the current directory
To Next Page
Loading...
Need help?
General
