Furutech DF-2 - Instructions


4. Instructions
1. Place the DF-2 on a level, stable surface as seen in the illustration below. Connect the provided AC
cord, and then unlock both latches.
2. Gently open the clamshell heating plates. The plates can only open 30 degrees and can be locked in
an open position using the side support bar.
3. Do not use excessive force.
4. Carefully set the LP on the center spindle.
5. To unlock the side support bar open the top plate to its fullest and close gently.
DO NOT LOCK TRANSPORT LATCHES DURING FLATTENING PROCEDURE.
They are for storage and transport only


























Heater Plate（Lid）
Handle
Trans
p
ort Latch
Heater Plate Base
Center S
p
indle
Vin
y
l LP