can adjust the volume of speakers or
speaker zones connected directly to the
stereo only.
Connecting the FUSION PartyBus
Device to a Wireless Access Point
1
Select > SETTINGS > NETWORK
> WI-FI CLIENT.
2
Select an option:
• Select SSID to display a list of
wireless access points in range.
• If you are connecting to the
wireless access point using WPS,
verify that WPS button has been
pressed on the access point, and
select WPS.
NOTE: It can take up to two
minutes to successfully connect to
the access point after you select
WPS.
3
If necessary, select an available
wireless network.
4
If necessary, enter the network
password.
5
Select SAVE.
Streaming from a FUSION PartyBus
Network Device
Before you can stream media from a
FUSION PartyBus stereo, you must
connect the device to the FUSION
PartyBus network using a wired or
wireless connection. See the Apollo
RA770 installation instructions.
You can stream media from an Apollo
RA770 stereo, but you cannot stream
media from another Apollo SRX400 zone
stereo.
1
Select
.
2
Press and hold the dial to select the
PARTYBUS tab.
The device shows a list of available
FUSION PartyBus stereos on the
network.
3
Select the stereo you want to stream
from.
The Apollo SRX400 zone stereo begins
streaming the same source as the
connected FUSION PartyBus device, and
a green border appears around the device
screen. All media playback functions affect
both devices.
6 Quick Start Manual
To Next Page
Loading...
