EasyManuals Logo

Fusion MS-RA60 Installation Instructions

Fusion MS-RA60
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Mounting Considerations
You must mount the stereo on a flat surface that provides open airflow around the rear of the stereo for heat
ventilation.
If you are installing the stereo in a location that may be exposed to water, you must mount it within 45
degrees of the horizontal plane.
If you are installing the stereo in a location that may be exposed to water, add a drip loop to the cable to
allow water to drip off of the cable and avoid damage to the stereo.
If you need to mount the stereo outside a boat, you must mount it in a location far above the waterline, where
it is not submerged, and where it cannot be damaged by docks, pilings, or other pieces of equipment.
To avoid interference with a magnetic compass, you must install the stereo at least 15 cm (5.9 in.) away
from a compass.
2 Fusion MS-RA60 Installation Instructions

Other manuals for Fusion MS-RA60

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fusion MS-RA60 and is the answer not in the manual?

Fusion MS-RA60 Specifications

General IconGeneral
BluetoothYes
AM/FM RadioYes
Zone Control2 Zones
DAB+ RadioNo
NMEA 2000Yes
Channels4
Impedance4 Ohms
Display2.3" LCD
USB PortYes
Water ResistanceIPX6
Operating Voltage10.8 - 16 V DC
Frequency Response20 Hz - 20 kHz