6 7
STEP 5
Remove lter/blade/receptacle
unit from base by grasping
the receptacle with two hands.
Then lift receptacle and twist in
either a clockwise or counter-
clockwise direction while pulling
in an upward direction until
lter/blade/receptacle unit is
separated from the main base.
STEP 4
Remove pulp collector by sliding
the bottom away from the base in
the direction of the arrows while
unhooking from under lip
on receptacle.
DISASSEMBLY (Cont.)
4
5
Note:
Do not remove screws from blade. The lter and the blade are one
piece. They are not meant to be separated.
Pulp
Collector
Lip
Base
Base
Receptacle
(Lift and Twist)
To Next Page
Loading...