18
TROUBLESHOOTING
• Check to see if unit is plugged in.
• Locking bar is not locked in place properly.
• Check if all parts are assembled properly.
• Check if there is any residue left between
blade and receptacle.
• Make sure you wait 5–10 minutes to restart
if machine automatically shuts down.
• Check that all parts are assembled properly
and in the correct position.
• Juicing overripe fruit may result in too much
pulp and will clog the lter. Turn machine off
and clean the lter.
• You may have applied too much pressure
with the pusher while processing caus
ing the motor to accidentally over heat.
This activates the built-in Thermal Cut Off
Switch. The motor will temporarily stop
working for approximately 10 minutes to
cool down. See additional information on
page 4.
• The motor needs to warm up for 5–10
seconds before rst use.
• The fruits and vegetables may be soft or
overripe.
• There may be too much pulp in the lter.
Turn machine off and clean the lter.
• This is normal.
• Make sure the non-drip spout is in the down
position while juicing. If it is in the upright
position the juice will not come out. It may
overow out the bottom sides
The motor does not
run after being
switched on.
The motor is
running with a loud
noise and excessive
vibration.
The motor overheats
causing the power
to automatically
shut off.
Juice splashes
from the rim
of the receptacle.
No juice is coming
out of the spout.
Problem
Possible Reasons and Solution
To Next Page
Loading...