FUTABA 12Z Series - Page 10

10
<Before Use>
&RQWHQWVDQG7HFKQLFDO6SHFL¿FDWLRQV
6SHFL¿FDWLRQVDQGUDWLQJVDUHVXEMHFWWRFKDQJHZLWKRXWQRWLFH
Your 12ZA/12ZH/12Z (packaged with a 14-channel PCM-G3 receiver) includes the following components:
• T12Z Transmitter, including RF module (MZ-DDS)
• R5014 Receiver
• LT2F2200 Li-ion battery & LBC-1D5 Charger
• NR4F1500 Ni-Cd battery & Charger (except for
Australia)
• Switch harness/DSC cord
• Hex Wrench (1.5mm, 2.5mm)
• Neck strap
The set contents depend on the type of set.
Transmitter T12ZA/T12ZH/T12Z
Operating system: 2-stick, 12 channels, PCM-G3,
synthesizer system
Transmitting frequency: 29, 35, 36, 40, 41, or 72 MHz
bands
Modulation: PCM-G3, PCM1024, or FM/PPM
switchable.
Power supply: 7.4V LT2F2200 Li-ion battery
Current drain: 500mA average
Receiver R5014DPS
(PCM-G3, Synthesizer, Dual conversion)
Receiving frequency: 29, 35, 36, 40, 41, or 72 MHz
bands
Intermediate freq.: 10.7 MHz & 450 kHz
Power requirement: 4.8 V Ni-Cd battery
Current drain: 75 mA
Size: 52x37.5x16.5 mm
Weight: 33 g.
Channels: 14
Suggested Servos for use with your 12Z
Servo S9154 (Digital servo)
Control system: Pulse width control, 1.52 ms neutral
Power requirement: 4.8 V (from receiver)
Output torque: 63.9 oz.-in. (4.6 kg-cm) at 4.8V
Operating speed: 0.14 sec/60 at 4.8V
Size: 1.87 x 1.06 x 0.97 in. (47.5 x 27.0 x 25.3 mm)
Weight: 1.87 oz. (53 g)
Servo S9255 (Digital servo)
Control system: Pulse width control, 1.52 ms neutral
Power requirement: 4.8 V (from receiver)
Output torque: 125.0 oz.-in. (9.0 kg-cm) at 4.8V
Operating speed: 0.16 sec/60 at 4.8V
Size: 1.57 x 0.79 x 1.44 in. (40.0 x 20.0 x 36.6 mm)
Weight: 1.94 oz. (55 g)