FUTABA 12Z Series - Page 89

89
<Model Menu (Airplane/Glider Functions)>
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR
ELEVATOR 2
AILVATOR
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
Setting method
ŏ0RYHWKHFXUVRUWRWKH$&7,1+LWHPDQG
turn the
data input dial to the left and push the enter
EXWWRQ21LVGLVSOD\HG
ŏ:KHQVHWWLQJDVZLWFKPRYHWKHFXUVRUWRWKH
>18//@LWHPRIWKHVZLWFKDQGSXVKWKHHQWHU
EXWWRQWRFDOOWKH6ZLWFK!VFUHHQDQGWKHQ
VHOHFWWKHVZLWFKDQGVHWLWV21GLUHFWLRQ$OZD\V
21DW18//VHWWLQJ
(For a description of the switch selection method,
see the description at the back of this manual.)
ŏ:KHQVHWWLQJDFRQGLWLRQGHOD\PRYHWKHFXUVRU
WRWKH&RQGLWLRQ'HOD\LWHPDQGVHWWKHGHOD\ZLWK
the data input dial.
ŏ&DPEHU$)5'5VFUHHQFDOO
 0RYHWKHFXUVRUWRWKH&DPEHU$)5LWHPDQG
push the enter button to call the setup screen.
(For a description of the setup method, see the
description at the back of this manual.)
&XUYHUDWHVHWXSVFUHHQ
ŏ7KHFXUYHDQGUDWHDUHDGMXVWHGE\FDOOLQJWKH
DLOHURQÁDSDQGHOHYDWRUFXUYHUDWHVFUHHQV
The rate and curve of each servo can be set by
calling each screen. (For a description of the
curve setting method, see the description at the
back of this manual.)
The servo speed can also be adjusted.