Steering Servo Reversing (REV-CH1)
NOR: Normal
REV: Reverse
(Selection key)
Steering Servo Reverse
This function reverses the rotation direction of
the Steering servo.
When the trim position deviates from the
center, the deviation will be on the opposite
side when the servo is reversed.
Model Selection/Model Reset (MDL)
The model selection selects the desired model memory from the 10 model memories
VWRUHGZLWKLQWKHWUDQVPLWWHUDQGWKHPRGHOUHVHWHUDVHVDOOGDWDVWRUHGLQDVSHFL¿FPRGHO
memory.
Model number
（1 - 0）
Model name
(Selection key)
Model Selection Model Reset
Push the DT2 lever up or down
for about one second.
All data stored in the current
selected model memory is
erased.
Throttle Servo Reversing (REV-CH2)
NOR: Normal
REV: Reverse
(Selection key)
Throttle Servo Reverse
This function reverses the rotation direction of
the throttle servo.
When the trim position deviates from the
center, the deviation will be on the opposite
side when the servo is reversed.
Steering End Point Adjustment (EPA-CH1)
Steering EPA
Adjust the travel of the servo
while operating the steering
wheel each way.
Range: 0 - 120%
(Left side) (Right side)
Use this function to limit the servo
movement to the left or right. The
servo travel to each side can be
independently adjusted. This
feature will compensate for any
difference in right or left turning
angles or radius due to the
characteristics of your model.
ｎ
WARNING
ｊ
Be sure that the steering linkage does not bind or come in contact with any
suspension parts or arms. If unreasonable force is applied to the servo, the
servo may be damaged and result in loss of control.
To Next Page
Loading...
