2. Separate the trims
3. Trim the model properly in all other conditions
4. Re-combine them - now the trim "offset" is permanent and any further trim in any
condition will maintain that offset when the trim is changed
How do I delete a condition or a whole model out of the Campac?
)<'<F-
''(6-"F)
)*"
)'.F-"
"FE-)
''
<
How do I start a brand new model in my Campac? I can't seem to select any of the
units in the Campac and start to edit it to make it a model?
--<"*"
)<"
'*@(
')
/"/"<@
I am setting up a twin engined-model and want to be able to command the engines
separately at certain times. Specifically, I always want the engines to respond only to
the throttle stick (never any knobs or other items), and I want the left engine to
operate alone if the C switch is in the up position with the right engine at idle; the
left and right engines operating together in the C center position, and the right
engine to operate alone in the C down position, with the left engine at idle. Can I do
this?
"-'
@*'*8)
To Next Page
Loading...
