)*5''$5*L
*DC//
5'$
Turn off the switch control
of channel 5 so it does not
operate like a gear servo.
Select Function (FNC) and
Set Gear Channel Null
Assignment
P B K O I P M M E M N R
Select Flaperon (FPN) and
Make Active
O D H A F N R
Set-up Flaperon
{if flap trim is desired, go to next ('R) and set a % ('C --
flaperons now trim on the left dial)} {adjust flap travel and
aileron differential if desired}
Select a Programmable Mix
(PMX) and Activate (ACT),
Flap Master (link on*) Gear
Slave 100% each way 0%
offset, No Switch
O B I F A F B J M C I D E R
F Q F O C M D M N P I N N
Mix channel 6 to channel 5,
causing channel 5 to obey
the normal flaperon (ch 6)
commands.
(*must turn link on "inbound" for this mix to obey the
flaperon mix)
If I am using the DSC or if I have used the A or R key during turn-on to keep the
transmitter from transmitting, do I still need to extend one section of the antenna or
remove the module?
(')/'"
"
Is there any risk to using cellular phones in close proximity with my radio?
)C55C
*
0!U6(<1
"*"C""
)0<<!3<
C''
**'
To Next Page
Loading...
