'//'''-"
'''
JF"H<9)'
"*&3B"
J
0'"$
9) "/
(K/@**
F/*
'@/"*"
*"*'
___Now, go to PMIX O B I
___Select an unused mix (example mix 1 -- F)
___Make it active A F
___Select speed brake as both master and slave B I C I
___Select type linear D E
___Trim inhibited R G
___Set the % as -100% on both sides, no offset (you can use an offset to fully close the
flaps if they aren't closing properly on their own) C M E D M E N
___Select the switch screen P then stick screen O
___Select throttle stick C
___
Put the physical throttle stick into the desired position for it to switch and then press
set Q
___Does it read ACT at the top of the scale and INH at the bottom? good. the mix is
active above that stick position and not below it. If its the other way around, press P
to reverse them.
)@
To Next Page
Loading...
