FUTABA FP-2PB - When Vehicle Will Not Be Used; Splined Horns; Angle Divisions and Effect

FP-S132H
[No. | Part No. |No.| Part name | Part_No.
| 1.| Uppercase | S05820 | 14.]| Intermediate shaft | 502480 |
| 3.| Bottom case | 805843 |16.| Ball bearing | S04130 |
| 4.| Metal bearing | 804137 [17.| Servo horn D_ | 501239 |
| 5.| Metal bearing | S04136 [18.| Horn mounting screw | J55178 |
| 6.| Potentiometer | | 39668 | 19. | S132HA Printed wiring board | AMS1100048 |
| 8.
| 9.| Motor pinion | 502788 J50083
S02787 S$132H Name-plate $60128
[11.| 2nd gear | S03250
503252
503254
4 SPLINED HORNS
This horn permits shifting of the servo neutral position at
the servo horn. Setting and shifting the neutral position.
a) Angle divisions
1) The splined horn has 25 segments. The amount of
change per segment is; 360 + 25 = 14.4° !
2) The minimum adjustable angle is determined by the
number of arms or number of the holes. For four arms,
the minimum adjustable angle is:
360° + (25 x 4) = 3.6°
Number of divisions
b) Effect
To shift the holes center line to the right (clockwise)
relative to baseline A, shift arm 2 to the position of arm
1 and set it to the position closet to baseline A.
[Example] For a four arm horn, the angular shift per
segment is 14.4°. The shift to the right is 90° — (14.4 x
6) =3.6°
To shift by the same angle in the opposite direction, use
the opposite arm number.
For a six arm horn, turn the arm counterclockwise and
set arm 2 to the position of arm 1. The adjustable angle is
60° — (14.4 x 4) =2.4°.
Arm 3 shift 4.8° to the right, arm 6 shifts 2.4° to the left,
and arm 4 shifts 7.2° to the right and left.
The following splined horns are optional.
HORN A HORN B HORN C
4 WHEN VEHICLE WILL NOT BE USED
Be sure and release the connector of running
Nicd battery except when you are on the way
to the starting line.
When not using the
connector, set the
switch to OFF.
Spas,
7 Release
“ the connector.
)>