FUTABA FP-2PB - Important: Receiver Antenna Routing; Antenna Routing Guidelines; Snow Is Water

IMPORTANT : Receiver Antenna Routing
To obtain the best possible range (car to transmitter
distance) and reduce the possibility of interference,
please observe these antenna routing instructions.
Failure to follow these guidelines can result in loss
of control or limited range.
1) NEVER cut your receiver's antenna wire.
Your system has been precisely tuned to the full
length of the stock antenna.
Excess antenna wire should NOT be tightly
coiled. To safely store the excess wire make
an antenna shortener from a small piece of stiff
cardboard. This will provide maximum reception
and prevent tangling and breakage of the wire.
2
—
3) When routing the antenna wire to the antenna
tube keep the wire away from battery and speed
control wiring. The high power of the NiCd
battery creates electrical “noise” which can cause
interference.
SNOW IS WATER
Remember that operating your FX10 on snow
or in wet areas is not recommended. Melted
snow becomes water which will damage or short
out your system's electronics.
FUTABA CORPORATION
FUTABA CORPORATION OF AMERICA
4. Studebaker, Irvine California 92718, U.S.A.
Phone: 714-455-9888 Telex: 23-0691227 Facsimile: 714-455-9899
EXTEND WIRE AT LEAST 1” BEYOND TUBE |
AND SECURE WITH KNOT
——ANTENNA TUBE
ANTENNA SHORTENER
SERVO TAPE
RECEIVER
KEEP ANTENNA WIRE AWAY FROM POWER WIRES
Tokyo Office: INAGAKI BLDG., 3F 1-21-3, Kanda sudacho, Chiyoda-ku, Tokyo, Japan.
Phone: (03)3255-6811 Facsimile: (03)3255-6880
Printed in Taiwan