Thank you for purchasing a
GYA460 ight control.
This document summarizes
the simple method of using the
GYA460.
For the detailed usage method
and precautions, refer to the
GYA460 6-axis Flight Control
instruction manual.
*For first flight aircraft, before
mounting the GYA460 have
a veteran flier make flight
adjustments without the GYA460
connected.
CONNECTION
THREE MODES
Aileron
Elevator
Rudder
Aileron2
Normal
Receiver
1 2
4 5 6
AIL
AIL2
ELE
RUD
GER
W
R
B
CONVENTIONAL CONNECTION S.BUS CONNECTION
S.BUS Port
S.BUS
Receiver
Aileron
Elevator
Rudder
Aileron2
6-axis Flight Control
Quick Reference
S.BUS
E/R/A2
AIL1
AIL1
AIL2
MODE
RUD
ELE
3-Signal
Cord
MOUNTING to the AIRPLANE
Firmly stick with the double side
tape supplied. Mount at a level
place near the center of gravity of
the fuselage where there is little
vibration.
*When mounting the to the side of the
airframe or when the label plate is at the
bottom, perform the mounting direction
setting described on pages 17 and 18 of
the instruction manual.
*Depending on the airframe material such
as balsa, etc., the adhesive strength of the
double sided tape may drop. In the case
of mounting on a less adhesive surface,
prepare the surface the best possible be-
fore mounting.
Beginner-MODE
<Blue>
GYRO-OFF
<Yellow>
・In this mode, the plane is not controlled by gyro
sensor.
GYRO-MODE
<Red>
S.BUS channel
setting of each servo
is unnecessary.
The GYA460 can even
be used with servos
other than S.BUS.
Mount the gyro facing forward
inside the fuselage.
The label of the
GYA460 faces up-
ward in the default
condition.
Make sure the gyro is
mounted level inside the
fuselage.
Extension
Cord
・This mode is suitable for level ight training of
beginners.
・The fuselage ight attitude angle is limited to
approximately ± 80° .
・When the transmitter sticks (except the throt-
tle) are set to neutral, automatic horizontal
level control returns the airplane to the level
state.
・This mode is suitable for inverted ight and
acrobatics.
・The plane is controlled by gyro sensor only.
・Fuselage attitude angle limit and automatic
horizontal level control are turned o.
・GYA460 : MODE ⇔ Extension Cord ⇔ RECEIVER : CH5
・GYA460 : AIL1 ⇔ Extension Cord ⇔ RECEIVER : CH1(AIL)
・GYA460 : E/R/A2 ⇔ 3-Signal Cord ⇔
White : ELE Red : RUD Black : AIL2
・GYA460 : S.BUS ⇔ Extension Cord ⇔ RECEIVER : S.BUS
Transmitter function
1CH:AIL1 2CH:ELE 3CH:THR
4CH:RUD 5CH:GEAR 6CH:AIL2