FUTABA SkyLeaf Leader - Page 14

9
Maingear
MounttheT-nutonthebottomofthemaingear.Drillasmallholewithadrillsothatthenailbitesasthe
materialishard.ThenfixT-nutwithepoxyglue.
Assemblethewheelandthewheelpants.Makesurethewheelsarelocatedinthecenterofthewheelpants
withthesuppliedwoodwashers.
InsertthemaingearinthefuselageandfixwiththeM3screw.Expanditbecausethegearinsertionholeof
thefuselageisnarrow.
Payattentiontothelengthsofthefrontandrear
screws.
Coolingairvent
Besuretoopentheairventonthelowersideofthe
rearpartofthefuselageforcoolingofthemotor
unit,ESC,etc.Thereisaguideattheendofthis
manual,souseit.Adjustthehardbalsawoodof
about5mmx10mmx230mmforreinforcement
insidethecenteroftheoutletafteropening.
InstallationofCanopystopper
Producethecanopystopperwiththeattachedcarbonrod.Reinforcetheinnersideofthefuselageofthe
mountingpartwithbalsawoodlike#45.Putthecarbonrodinthecenter.Adherethecenter.Adhereplastic
ballstobothendsofthecarbonrod.
42 43
45 46
44
41