Need help?Do you have a question about the FUTABA CGY750 and is the answer not in the manual?
Critical safety instructions for pre-flight checks and general operation.
Safety advice specific to governor function, including failsafe and pitch.
Instructions for connecting gyro sensor, revolution sensor, S.Bus, and servos.
Step-by-step guide for basic rudder gyro configuration.
Selecting servo type and setting gyro compensation direction.
Configuring servo limits and selecting flight modes.
Setting gyro direction and adjusting gyro gain for the elevator.
Selecting the operational mode for the elevator gyro.
Selecting swash plate type and cyclic servo type.
Choosing helicopter presets and flight mode presets.
Configuring servo operational direction and neutral points.
Adjusting swash AFR for throw and preventing servo binding.
Detailed instructions for mounting and aligning the gyro sensor correctly.
Overview of swash plate types and initial servo installation steps.
Adjusting servo movements for collective pitch and cyclic controls.
Steps to finalize gyro setup using transmitter gain functions.
Detailed procedures for adjusting gyro gains manually.
Comprehensive checklist of essential checks before each flight.
Guidance and warnings for performing test flights and initial adjustments.
Specific tuning steps and gain adjustments for the rudder gyro.
Setting main rotor RPM, inputting gear ratio, and configuring servo type.
To Next Page
General
