G
YRO
S
ENSOR
I
NSTALLATION
Important: The CGY750 gyro sensor must be
mounted so that the roll and pitch sensing axis
are in alignment with the helicopter. Any misalign-
ments over 1/2 of a degree will cause a loss in
performance. Please take extra care in this step
to ensure the optimum flight performance.
TROUBLESHOOTING
If any issues are noted during flight (such as
drifting, inconsistent hold or inconsistent control
rates) then please review the following trouble-
shooting recommendations.
1. Always verify that the tail rotor and swash plate
mechanisms operate, and that the drive system
s4HE BOTTOM OF THE #'9 'YRO
Sensor must be perpendicular to
the main shaft.
s4HEROLLAXISMUSTBEPARALLELTO
the tail boom and the pitch axis
must be perpendicular to the side
frame.
51
To Next Page
Loading...
