FUTABA CGY750 - Servo Reverse and Neutral Settings

S
WASH
B
ASIC
S
ETTING
46
(7) Elevator servo reverse [default: Normal]
This setting is used to set the operational direc-
tion for the Elevator CCPM servo. The easiest
way to set up the CGY750 is to observe which
direction each servo needs to move when the
collective stick is moved towards positive col-
lective pitch. If the servo is moving the wrong
direction, then press the data [+] or [-] key to
reverse that specific servo within the GY750.
Once the collective is operating in the correct
direction check the cyclic controls. If the cyclic
controls operate in the wrong direction, reverse
THE3WASH!&2FORTHATFUNCTIONWITHINTHE
CGY750.
(6) Aileron servo reverse [default: Normal]
This setting is used to set the operational direc-
tion for the Aileron CCPM servo. The easiest
way to set up the CGY750 is to observe which
direction each servo needs to move when the
collective stick is moved towards positive col-
lective pitch. If the servo is moving the wrong
direction then press the data [+] or [-] key to
reverse that specific servo within the GY750.
Once the collective is operating in the correct
direction, check the cyclic controls. If the cyclic
controls operate in the wrong direction, reverse
THE3WASH!&2FORTHATFUNCTIONWITHINTHE
CGY750.