FUTABA CGY750 - Page 47

S
WASH
B
ASIC
S
ETTING
47
(8) Pitch servo reverse [default: Normal]
This setting is used to set the operational direc-
tion for the Pitch CCPM servo. The easiest way
to set up the CGY750 is to observe which direc-
tion each servo needs to move when the col-
lective stick is moved towards positive collective
pitch. If the servo is moving the wrong direction,
then press the data [+] or [-] key to reverse that
specific servo within the GY750. Once the col-
lective is operating in the correct direction check
the cyclic controls. I the cyclic controls operate
INTHEWRONGDIRECTIONREVERSETHE3WASH!&2
for that function within the CGY750.
(9) 2nd Elevator reverse [default: Normal]
This setting is used to set the operational di-
rection for the 2nd Elevator CCPM servo (only
used for the H4-xx Swash plate types). The
easiest way to set up the CGY750 is to observe
which direction each servo needs to move when
the collective stick is moved towards positive
collective pitch. If the servo is moving the wrong
direction, then press the data [+] or [-] key to
reverse that specific servo within the GY750.
Once the collective is operating in the correct
direction, check the cyclic controls. If the cyclic
controls operate in the wrong direction, reverse
THE3WASH!&2FORTHATFUNCTIONWITHINTHE
CGY750.
* This function is only used with the H4 swash plate
types. Otherwise the function is disabled.