FUTABA T32MZ

167
＜
Model Menu (Helicopter Functions)
＞
+(/,&237(5
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
Ɣ7KroWWle Curve ([ample
The curves shown below were created by using the Line
mode and inputting the data of the 5 points 0% (low
side), 25%, 50% (center), 75%, 100% (high) side at each
condition. They were created by reducing the number
points of the line to 5. When actually creating a curve,
HQWHUWKHGDWDVSHFL¿HGSHUWKHIXVHODJHRUWKHUHIHUHQFH
value).
Curve setting examples
ŏ5HWXUQWR0RGHO0HQX
7KURWWOH+RYHUWULP
7KH7KURWWOH+RYHUWULPVHWXSVFUHHQFDQEHVHOHFWHGIURPWKH7+5&XUYHVHWXSVFUHHQ
ŏ6HWV7KURWWOH+RYHUWULP
ŏ6HWVWKHGLDOXVHG
The Throttle Hover function trims the throttle near
the hovering point. Normally, use it with hovering
FRQGLWLRQV&KDQJHVLQURWRUVSHHGDFFRPSDQ\LQJ
changes in the temperature, humidity, and other flight
conditions can be trimmed. Adjust the throttle so that
rotor rotation is most stable. More delicate trimming is
also possible by using this function along with the Hover
Pitch function.
Setting method
ŏ:KHQXVLQJWKHKRYHULQJQRUPDOFRQGLWLRQRQO\VZLWFK
WKH>*U@JURXSEXWWRQPRGHWRWKH>6QJO@VLQJOH
PRGHDQGPDNHWKHVHWWLQJV
ŏ6HWWKHIXQFWLRQWR$&7>21@
ŏ6HOHFWWKHDGMXVWPHQWNQRE6HOHFWLRQH[DPSOH5'
ŏ7KHWULPRSHUDWLRQPRGH0RGH&7501250FDQEH
selected.
CTRM mode:0D[LPXPFKDQJHQHDUFHQWHUE\FHQWHU
WULPRSHUDWLRQ'RHVQRWFKDQJHDWHQGRIWKHVWLFN
PRYHPHQW
NORM mode: 1RUPDOWULPOLQHDURSHUDWLRQ7KH
DGYDQWDJHRIXVLQJWKLVPRGHLVWKDWKRYHULQJWKURWWOH
FDQEHDGMXVWHGZLWKRXWFKDQJLQJWKHFXUYH
ŏ7ULPDGMXVWPHQWUDQJH5DQJHVHWWLQJ
 :KHQWKHYDOXHLVPDGHVPDOOWULPDFWVRQO\QHDUWKH
center.
ŏ7KHWULPUDWHFDQEHDGMXVWHGDQGWKHRSHUDWLRQ
direction can be set.