41
<
Basic Operation
>
0RGHO,'
)$667HVW7)+66
For the sake of safety, this function does not operate the receiver if the model data of the model program settings that
does not match the aircraft is used by mistake.
Ŷ,QWKHV\VWHPW\SHV)$667HVW7)+66FRPSDWLEOHZLWKWKHPRGHO
,'IXQFWLRQDXQLTXH,'QXPEHUPRGHO,'LVVHWWRHDFKPRGHO
data. Linking with a receiver stores the model ID of the model data
in that receiver. The receiver operates only when it receives radio
waves transmitted using model data that matches the stored model
ID. As a result, the receiver does not operate even if model data of an
unintended setting is used by mistake, so it is possible to prevent a
malfunction due to a model selection mistake.
Link is required when a new model is made from a model selection.
Model1Receiver
Addnewmodeldata
Link
SelectamodelinModelSelect.Linkwithareceiverthatmatchesthemodel.
Link
Link
Model2Receiver
Model3Receiver
1:
3:
Model1
Model2
Model3
2:
1:
3:
Model1
Model2
Model3
2:
1:
3:
Model1
Model2
Model3
2:
1:
3:
Rx1
Rx2
Rx3
Model1
Model2
Model3
2:
SelectModel2
Itworkswithdifferentmodeldata.
Thereisariskofflyingwithdifferentmodeldata!
SelectModel2
Model2onlyworkswithModel2data.
Thereisnoriskofflyingwithdifferentmodeldata.
Conventionalsystem
ModelID
Operation
Operation
Rx1
Rx2
Rx3
Operation
Operation
1:
3:
Model1
Model2
Model3
2:
NotOperation
NotOperation
WhenusingR3004SB
■
When using the R3004SB, set “Receiver” in the system type screen T-FHSS mode setting to [R3004SB].
When using other T-FHSS compatible receivers, set "Receiver" to [Normal].
R3004SB receiver does not
support model ID function.
Changeto"R3004SB"
Ŷ,I\RXZDQWWRXVHGLIIHUHQWPRGHOGDWDIURPWKHPRGHOGDWDWKDW\RX
have been using, link again.
Ŷ0RGHO,'IHDWXUHLVHQDEOHGRQO\LIWKHV\VWHPW\SHLV)$667HVWRU
T-FHSS. Please note that model ID function can not be used on other
systems.
Ŷ)RUVDIHW\UHDVRQVPRGHO,'IXQFWLRQFDQQRWEHGLVDEOHG
Ŷ0RGHOGDWD WKDWFDQEHVWRUHGLQLQWHUQDOPHPRU\LVXSWR
models.
Ŷ0RGHO,'LVDXWRPDWLFDOO\VHWZKHQFRS\LQJRUDGGLQJPRGHOGDWD