Water Bee™ Pedal Boat Owner’s Manual and Assembly Guide
B) Backrest installation
1. Your backrest will
come with seat clips
attached to backrest.
2. Using a Phillips star
screwdriver remove
screw and clip from
backrest.
3. Turn backrest over
and repeat previous
rocedure (step 2).
4. Using a flat
screwdriver, pry apart
seat clips from
backrest.
5. Ensuring that backrest is
reclined towards rear of
boat, place backrest
(without clips and screws)
onto adjustment rail as
shown above.
6. Place one seat clip and
screw onto one side of the
backrest (seat clip should
be placed underneath
adjustment rail).
7. Repeat previous
rocedure on other
side of the backrest.
9. Using your Phillips
star screwdriver,
attach seat clip to
backrest tightly.
8. Push seat clips firmly
into the backrest with
hands, or with hammer, if
required.
10. Repeat previous
rocedure on the other
side of the backrest.
12. Install the backrest
into the adjustment
slot of choice
Future Beach
™ Corporation
The World’s Beach Company
™
5
11. Swing backrest
towards the center of
To Next Page
Loading...
