Future Beach WB 200 - Page 8

Water Bee™ Pedal Boat Owner’s Manual and Assembly Guide
11. Clip the tie-down cord
onto the D-ring, which
you have previously
installed (steps 1-2) at the
rear of the hull. Repeat
with second tie-down
cord.
10. Take the tie-down
cord and pull bimini
gently towards the
back of the hull
9. Place two large
bimini poles snugly
and firmly into holes
for bimini at the front
of the hull.
13. Position your
bungee cord as shown
above, with cord loop
above the bimini pole
and the adjuster piece
b
elow the
p
ole.
12. Take adjustable
bungee cord and raise
it to the first weave in
your bimini, as shown
above.
14. Holding the cord in
p
lace, pass the loop over
the pole and around
adjuster piece.
15. Pull down on
adjuster piece to
tighten the bungee
cord to the bimini
p
ole. Repeat steps 12-
15 on other side of
boat
16. Adjust your canopy in your
desired way: pull it back for more
exposure to the sun, or push it
forward for more shade. Lock your
canopy in your desired position
with the bungee cord.
Future Beach
™ Corporation
The World’s Beach Company
™
8