28
- DMX values
Readout DMX values of each channel received by the fixture. Use the [Up] and [Down] keys to select desired
channel and press [Enter] to read its value coming to the fixture or [Mode] to cancel and return to the menu.
- Automatic blackout of Display
This function allows you to keep the display On or to turn Off automatically 2 minutes after last pressing any key
on the control board. Use the [Up] and [Down] keys to select "On" if you wish to keep the display "On" or "Off"
if you wish to turn Off automatically 2 minutes after last pressing any key on the control board and press [Enter]
to confirm or [Mode] to cancel and return to the menu.
- Display intensity
By this function you can adjust from 20 to 100 the intensity of the display. Use the [Up] and [Down] keys to
select the level of the display intensity and press [Enter] to confirm or [Mode] to cancel and return to the menu.
- Lamp Off via DMX
This function allows you to switch Off the lamp by DMX. Use the [Up] and [Down] keys to select "On" if you
want to switch Off the lamp by DMX or "Off" if you don’t want to switch Off the lamp by DMX and press [Enter]
to confirm or [Mode] to cancel and return to the menu.
- Temperature
Temperature readouts of fixture inside in Celsius. Inside temperatures below 60° C are not critical. 60° C and
more lead to the lamp being switched off. Please note that the outside temperature should not exceed 50° C.
- Low fan speed operating
By using this function you can choose 3 types of low fan speed operating. Browse through this menu by the
pressing [Up] and [Down] keys - the display shows step by step these messages: "reG, Lo.HI, Lo.OF". Press
[Enter] if you wish to select one of them or [Mode] to cancel and return to the menu.
To Next Page
Loading...
