What to do if FutureLogic GEN3 Evolution fails to restart while loading BSP SPC bundle?
If your FutureLogic Printer fails to restart while loading the BSP SPC bundle, it's likely because the device doesn't automatically reset during the BSP SPC firmware download. To resolve this, power cycle the printer. This will restart the printer in BSP mode.
What to do if FutureLogic GEN3 Evolution Printer shows error when converting from SPC protocol to DFU?
If you encounter an error when converting from SPC protocol to DFU on your FutureLogic printer, it might be due to a timeout during the initial driver installation. To fix this, close the application and restart the printer.
Why does my FutureLogic GEN3 Evolution Printer appear as two devices in Device Manager (CDC)?
The FutureLogic printer might appear as two devices in Device Manager (CDC) because RS232 applications use a composite device with two interfaces for the printer: DFU run time and CDC. To resolve this, cancel any new hardware wizard.
General| Brand | FutureLogic |
|---|---|
| Model | GEN3 Evolution |
| Category | Printer |
| Language | English |
To Next Page
