What to do if FutureLogic GEN3 Evolution fails to restart while loading BSP SPC bundle?
If your FutureLogic Printer fails to restart while loading the BSP SPC bundle, it's likely because the device doesn't automatically reset during the BSP SPC firmware download. To resolve this, power cycle the printer. This will restart the printer in BSP mode.
What to do if FutureLogic GEN3 Evolution Printer shows error when converting from SPC protocol to DFU?
If you encounter an error when converting from SPC protocol to DFU on your FutureLogic printer, it might be due to a timeout during the initial driver installation. To fix this, close the application and restart the printer.
Why does my FutureLogic GEN3 Evolution Printer appear as two devices in Device Manager (CDC)?
The FutureLogic printer might appear as two devices in Device Manager (CDC) because RS232 applications use a composite device with two interfaces for the printer: DFU run time and CDC. To resolve this, cancel any new hardware wizard.
General| Brand | FutureLogic |
|---|---|
| Model | GEN3 Evolution |
| Category | Printer |
| Language | English |
Covers the standard usage of the GEN3 Evolution printer.
Step-by-step guide on loading tickets into the printer.
Procedures for clearing a ticket jam.
Instructions for printer maintenance and service.
Steps to remove the printer from its mounting.
Procedures and recommendations for cleaning the printer.
Procedure to print the standard configuration ticket.
Procedure to print the extended configuration ticket.
Steps to set printer communication parameters.
Procedure to remove the Memory/LED Module.
Introduces methods for upgrading printer firmware.
Steps for USB plug-in firmware upgrade.
Steps for upgrading via FLDFU program.
Instructions for installing FLDFU and drivers.
Step-by-step guide for firmware upgrade using FLDFU.
Solutions for common ticket printing problems.
Troubleshooting printer conditions using LED status.
Lists error conditions and their remedies.
To Next Page
