What to do if my FUXTEC FX-FSR152 has no ignition?
If your FUXTEC Brush Cutter has no ignition, it could be due to a carbon deposit between the diodes of the spark plug, in which case you should clean the spark plug. Alternatively, the ignition coil might be defective, requiring you to replace it. Another possible cause is a flywheel that is too weak, so replace the spark or flywheel.
Why is my FUXTEC FX-FSR152 difficult to operate?
If you're experiencing difficulties operating your FUXTEC Brush Cutter, the choke might be in the "COLD START" position; open the choke. Another cause may be a blocked exhaust system, so check or replace the exhaust system. Also, worn moving elements can cause operational issues; adjust the ignition spark.
What to do if my FUXTEC Brush Cutter carburettor is leaking?
If the carburettor of your FUXTEC Brush Cutter is leaking, it might be due to a failure of the check valve on the tank cap; replace the fuel filler cap. It could also be that the carburettor gasket is worn out, so replace the carburettor or gasket.
Why does my FUXTEC Brush Cutter have weak ignition?
A weak ignition in your FUXTEC Brush Cutter can be caused by worn piston rings, a spark plug that isn't screwed down, a cylinder head that isn't tight, incorrect valve clearance, or incorrect ignition timing. Ensure a regular oil supply. Another potential cause is poor contact between the ignition cap and spark plug; replace or check these components.
How to fix a FUXTEC Brush Cutter with no ignition spark?
If your FUXTEC Brush Cutter has no ignition spark, it could be due to carbon deposits between the diodes of the spark plug, or a defective ignition coil or weak flywheel magnet. Clean the spark plug and adjust the gap to 0.6~0.7mm, or replace the spark plug, ignition coil, or flywheel.
Why is the carburetor leaking on my FUXTEC FX-FSR152?
If the carburetor is leaking on your FUXTEC Brush Cutter, it could be due to a failure of the check valve on the tank cap or a worn-out carburetor gasket. Replace the fuel filler cap, or the carburetor or gasket.
Why doesn't the engine reach full speed on my FUXTEC FX-FSR152 Brush Cutter?
General| Brand | FUXTEC |
|---|---|
| Model | FX-FSR152 |
| Category | Brush Cutter |
| Language | English |
To Next Page
