Original User Manual FUXTEC petrol leaf vacuum cleaner / blower FX-LBS126 / FX-LB126_rev05
13
11. Commissioning - refuelling, 2-stroke engine oil
The device is not delivered filled with fuel mixture.
Fill the device as described in this chapter under "Refuelling".
The device is operated with a 40:1 mixture of normal fuel (unleaded) and two-stroke engine
oil.
When handling petrol, increased attention is required. Avoid smoking and naked
flames at all costs because of the danger of explosion.
Gasoline:
Octane number at least 91 RON, lead free
• Do not fill with leaded fuel, diesel or other non-approved fuels.
• Do not use fuel with an octane number lower than 91 RON. This can lead to engine damage
due to increased engine temperatures.
• If you work continuously in the higher speed range, use fuel with a higher octane rating.
• For environmental reasons, the use of unleaded petrol is recommended. The use of E10 fuels
is not permitted.
2-stroke engine oil
Do not use four-stroke or two-stroke oils for water-cooled outboard engines, or ready-mixed
fuel from petrol stations.
Mixing ratio 40:1
• Ensure that the oil quantity is measured exactly, as a small deviation in the oil quantity has a
strong effect on the mixing ratio for small quantities.
• Do not change the mixing ratio, as this will result in increased combustion residues, increased
fuel consumption and reduced performance, or damage to the engine.
Mix the fuel and oil in a clean, petrol approved and marked container with overfill protection.
1. First fill in half of the fuel to be mixed
2. Then fill in the entire quantity of oil.
3. Shake the mixture.
To Next Page
Loading...
Need help?
General
