Original User Manual FUXTEC petrol leaf blower FX-LB133T_rev06
13
10. Commissioning - refuelling, 2-stroke engine oil
The device is not delivered filled with fuel mixture.
Fill the device as described in this chapter under "Refuelling".
The device is operated with a 40:1 mixture of normal petrol (unleaded) and two-stroke engine
oil. For the first tank filling we recommend a mixture of 25:1. Use of ready-mixed or special fuels
can cause damage to the device.
When handling petrol, increased attention is required. Avoid smoking and naked
flames at all costs because of the danger of explosion.
Gasoline:
Octane number at least 91 RON, lead free
• Do not fill with leaded petrol, diesel or other non-approved fuels.
• Do not use petrol with an octane number lower than 91 RON. This can lead to engine damage
due to increased engine temperatures.
• If you work continuously in the higher speed range, use petrol with a higher octane rating.
• For environmental reasons, the use of unleaded petrol is recommended. The use of E10 fuels
is not permitted.
2-stroke engine oil
Do not use four-stroke or two-stroke oils for water-cooled outboard engines, or ready-mixed
fuel from petrol stations.
Mixing ratio 40:1
• Ensure that the oil quantity is measured exactly, as a small deviation in the oil quantity has a
strong effect on the mixing ratio for small quantities.
• Do not change the mixing ratio, as this will result in increased combustion residues, increased
fuel consumption and reduced performance, or damage to the engine.
Mix the petrol and oil in a clean, petrol approved and marked container with overfill protection.
1. First fill in half of the petrol to be mixed
2. Then fill in the entire quantity of oil.
To Next Page
Loading...
Need help?
General
