Standard Operating Manual FUXTEC FX-MHP126_rev03
12
shape.
e. After mounting the cutting blade and tightening the screw, check that it is properly
fastened. The blade must not have any play to avoid excessive vibration throughout
operation.
BEFORE USE
a. Before starting work, check the working area to avoid injury from obstacles such as
tree stumps, stones, tin cans or broken glass. Before starting work, remove all obstacles
(terrain conditions, characteristics of the meadow, position of the obstacles, danger of
the surroundings).
b. When working with the device, a radius of 15m is considered to be a danger area,
which must not be entered by anyone. If necessary, this danger area must be marked
with a warning tape or with warning signs. If two or more persons are working at the
same time, always maintain a sufficient safety distance.
c. Start the engine after being instructed in the manual and make sure that the cutting
blades do not move when the engine is in idling.
DURING USE
a. Grip the handles firmly with both hands. When stopping work, first reset the throttle
to "start speed", then release the device.
b. When working, always ensure that the device is firmly balanced.
c. Always keep the engine speed at the level required for cutting and never increase it
unnecessarily.
d. If you want to remove branches that have wrapped around the cutter, or if you want
to check the device or cutter, the engine must first be stopped. Wait until the cutter has
stopped completely, only then can such actions be performed.
e. If the cutting blade has been collided with hard objects such as stone, stop the
engine immediately and then check the cutting blade. If the cutting blade is damaged, it
must be replaced immediately.
f. If work is interrupted by a third party, always switch off the engine before turning
around.
g. To avoid electric shock, it is forbidden to touch the spark plug and cable when the
engine is running.
h. Never touch the muffler, spark plug or other metal parts of the engine when the
engine is running or immediately after switching off the engine. Doing so may cause
severe burns or electric shock.
i. If two or more persons are working at the same time, always maintain a sufficient
safety distance.
To Next Page
Loading...
Need help?
General
