Standard Operating Manual FUXTEC FX-MHP126_rev03
13
NOTES ON KICKBACK
Kickback of the device means that the device shakes heavily when the fast-moving
cutters hit hard objects such as stone, concrete, wooden piles, etc. This unexpected
Kickback can prevent the operator from operating the device properly. To avoid this
kickback, the following notes must be observed.
• Avoid colliding with hard objects, such as a pole, steel cable, rocks. This can
prevent damage to the cutting device.
• Grip the handles firmly with both hands.
• During use, your eyes must focus on the cutter, otherwise the throttle lever must
be reset to "start speed".
• Hold the device far enough away from your feet.
MAINTENANCE INSTRUCTIONS
• To ensure proper operation, the device must be regularly maintained and
checked according to the instructions in this manual. If it is necessary to replace
any part or perform any maintenance or repair work not described in this
manual, contact FUXTEC UK.
• Under no circumstances should the device be disassembled or modified in any
way. This could cause damage or operating errors.
• Always switch off the engine before carrying out any maintenance or inspection.
• Always wear sturdy gloves when assembling/disassembling and grinding the
cutter to prevent hand injuries.
To Next Page
Loading...
Need help?
General
