Original Bedienungsanleitung FUXTEC FX-MS125_de_en_fr_ita_es_rev01
44
● Children must not have access to the device. Spectators should stand at least 15
meters away from the working area.
● Keep hands and feet away from the nylon cutting head or metal blade during
operation.
● Do not use the device if you are tired, ill, or under the influence of medication,
drugs, or alcohol.
● Use an undamaged nylon cutting head. Stop the device and check the nylon
cutting head if you hit a stone or any other obstacle. Never use a defective or
unbalanced nylon cutting head.
● Before starting, after failure or impact, always check the device and make sure it
is in good condition.
● Attention! Local regulations may limit the use of the device
● Always keep the device with the cutting tool in good condition. Note improper
maintenance, the use of non-compliant spare parts, or the removal or
modification of safety devices can cause damage to the device and severe injury
to the person working with it.
● Secure the device well during transport to prevent fuel loss, damage to the
device, and injury. Always fit the transport protection of the cutting blade before
transporting or stowing the device.
● On devices with a clutch, check that the cutting attachment stops rotating when
the engine is idling.
● Always check the device for loose fasteners, fuel leaks, damaged parts, etc.,
before each use. Replace used parts before use.
● It is necessary to take sufficient breaks and change the working position.
● Do not store the device in a closed area where fuel vapours can reach an open
fire from water heaters, stoves, etc. Store the device in a well-ventilated area
only.
● IMPORTANT: When filling the fuel, ensure the engine is off and cooled down.
Never refuel when the device is running or hot.
To Next Page
Loading...
Need help?
General
